Translate

2023年1月1日星期日

JCB Excavator 3CX 4CX Changing the Oil and Filter Guide

                       JCB Excavator 3CX 4CX  Changing the Oil and Filter Guide


When draining JCB 760 Series Powershift gearboxes it is
recommended that the oil is drained through the cover plate
A to make sure that the debris collected in the transmission
sump is flushed out. Draining oil through the sump plug will
filter oil through the strainer and not flush out the debris.


                                 WARNING!
Make the machine safe before getting beneath it. Lower
the attachments to the ground; engage the parking
brake; remove the starter key, disconnect the battery.


JCB ServiceMaster 4 v22.9.3 [12.2022] Diagnostic Software Download and Installation



 1 Park the machine on firm level ground, apply the park
brake. Lower the loader arms, open the engine bonnet,
raise the loader arms and fit the safety strut. Lower the
excavator to the ground, switch OFF the engine and
remove the starter key.
2 Apply the parking brake and disconnect the battery,
remove the engine side panels.
3 Place a container of suitable size beneath the
transmission to catch the oil.
4 Remove bolts B. Pull off cover plate A and gasket C,
allow the oil to drain into the container. Be aware that
the oil may be hot.
Note: When the cover is removed oil will gush out. Keep to
one side when you remove the cover plate.


2017 JCB Service Parts Pro+Service Repair Download



5 Fit cover plate A and a new gasket C. Apply JCB
Threadlocker and Sealer to bolts B before fitting them.
Torque tighten the bolts to 28 Nm (20.5 lbf ft.).
6 Unscrew and remove the filter D. Fit the new filter:
6.1 Smear seal E with transmission oil.
6.2 Screw the filter on until it just contacts the filter
head.
6.3 Turn the filter at least another 3/4 of a turn.
7 Fill the system with new oil through the dipstick/filler F.
Do not fill past the top mark on the dipstick.
8 On completion check for oil leaks.
Note: Fit only a genuine supplied JCB filter, otherwise
damage to the system may be incurred through
contamination.

没有评论:

发表评论

How to relieve hydraulic pressure in the hydraulic circuit of a CAT excavator.

  How to relieve hydraulic pressure in the hydraulic circuit of 312D2 and 313D2 excavators   Steps to relieve pressure:   Caterpillar ET 202...