How to commission a DFP2012 / DFP1013 Deutz diesel engine

                  https://www.heavydutydiag.com/                          

   Commissioning

This section contains information regarding the commissioning of your engine.

Adding Engine Oil

1 Never add oil to the engine while it’s running 

 

2024 Deutz SerDia 4.0 SerDia2010 14.1.9.3 Highest Level 6 Diagnostic Software

 

  2 Initial Engine Oil Fill-Up

 3  Adding Fuel

     Use only commercial-grade diesel fuel. For fuel grade, see section 4.2. Use summer or winter-
grade fuel, depending on the ambient temperature.
Never.fill.the.tank.while.the.engine.is.running.•
Ensure cleanliness!•
Do not spill fuel!•
DO NOT• use BIO-DIESEL; bio-diesel can cause the fuel injection components to stick
if.the.engine.is.not.run.for.an.extended.period.of.time.

4.
See sections 6.3.1, 6.3.2 and 8.2 for this information as it pertains to each engine. 

5.
Check the battery and cable connections, see section 6.6.1.1.•
Trial run:•
After.the.engine.has.been.prepared,.carry.out.a.brief.trial.run.for.approximately.o
10 minutes UNLOADED, if possible.
During and after the trial run:•
Check the engine for leakso
After the engine has been turned off:•
Check the oil level and top off, if necessary, see section 6.1.2o
Re-tension V-belts, see section(s) 6.4.1 – 6.4.1.5 

 

  5 This section pertains to the method(s) for starting your engine.

Electric Starting 

 

  

 

6 Starting via Control Panel

 a  Put the MODE SELECTOR switch to MANUAL START.

                        

 

 

Deutz Diagnostic Tool Communicator for Deutz Engine DECOM Controllers

  b Lift and hold the MANUAL CRANK “2. A” switch, releasing it when the engine starts.
Attempt to start the engine for 15 seconds.

                                       

    

c If the engine doesn’t start lift and hold the MANUAL CRANK “3. B” switch and release it
once the engine starts. Attempt to start the engine for 15 seconds. 

                          

  f If the starter engages and turns the engine but it doesn’t crank and run; then alternate4.
between the “MANUAL CRANK A” and “MANUAL CRANK B” switches. 

 g  If the starter engages for every starting attempt and the engine fails to run; then consult5.
the fault table in section 7.1 or call DEUTZ service department. 

h If the starter fails to engage and crank the engine then try starting the engine as outlined6.
in section 3.2.3 entitled “Starting via Manual Solenoids 

 

7 Starting via Manual Solenoids 

a  Put the MODE SELECTOR switch to MANUAL START.

b Lift and hold the manual crank “A” solenoid lever and release it once the engine starts.2.
Attempt to start the engine for no longer than 15 seconds. 

 c If the engine3. does not start then repeat step 2 above using manual crank “B” solenoid. 

               

         

  D If the starter engages and turns the engine but it doesn’t crank and run; then alternate4.
between the “MANUAL CRANK A” and “MANUAL CRANK B” switches.

  E If the starter engages for every starting attempt and the engine fails to run; then consult5.
the fault table in section 7.1 or call DEUTZ service department.