Perkins Engine Exhaust Gas Valve (NRS) -Assemble Guide

      This article mainly introduces Perkins 2806F Engine Exhaust Gas Valve (NRS) -Assemble guide

Perkins SPI2 VERSION 2018A Service & Parts CATALOGUE SOFTWARE

1. Ensure that all components are clean and free from wear and damage. If necessary, replace any components that are worn or damaged.

Perkins EST Electronic Service Tool Diagnostic Software Full Function 2020a

2. Place valve housing(11) into a suitable support.

3. Install a new O-ring(10) to valve housing (11).

   Ensure that the O-ring seals are correctly installed into the recesses of the valve housing.
4. FilCavity(B) with Tooling(A). Cavity(B) is found on the valve housing(11).

5. Installactuator assembly(6) to valve housing(11).

   Ensure that the actuator assembly is correctlyseated and correctly orientated onto the valve housing.

6. Install Allen head bolts and washers(3). Tighten Allen head bolts to a torque of 28 N·m (248 lb in).

7. Install O-ring(13),O-ring(14),O-rings(15), and
   (16) to valve assembly(7).

8. Installvalve assembly (7) to actuator assembly(6).
   Tighten the valve assembly to a torque of 50 Nm
   (37 Ib ft).

9. Install solenoid (8) to valve assembly(7). Ensurethat the solenoid is correctly orientated. Install washer(9) and nut(9a). Tighten the nut toa torque of 20N-m(177 lb in).

10. If necessary, install temperature sensor (12) to valve housing(1). Refer to Disassembly and Assembly, Temperature Sensor(Cooled Exhaust Gas)-Remove and Install for the correct procedure.

Perkins Engine ECM Flash File Download

11. Install a new O-ring seal (2) to adapter(1). Install the adapter to actuator assembly (6). Tighten the adapter to a torque of 20 N-m (15 Ib ft).

12. Install a new O-ring seal(5) to adapter(4). Install the adapter to actuator assembly (6). Tighten the adapter to a torque of 20 N-m(15 b ft).