Loader Arm Safety Strut Removal and Installation Guide

   This article mainly introduces Removal and Installation of the 3cx,4cx Loader Arm Safety Strut

JCB Service Master 4 v22.9.3 [10.2022] Diagnostic Software Download

Installing
 Install the loader arm safety strut as detailed below before working underneath raised loader arms.
AWARNING Raised loader arms can drop suddenly and cause serious injury. Before working under raised loader arms, fit the loader arm safety strut.

1 Empty the Shovel and Raise the Loader Arms fully.

2 Stop the Engine Remove the starter key.
             WARNING
  You could be killed or injured if the loader control is accidentally operated. Make sure no-one comes near the machine while you release the safety strut.

3 Release the Strut
   a Release fastener A.
   b Remove stnut C from its stowage bracket.

4 Install the Strut
   a Push strut C over the ram piston rod.
   b Secure the strut in position with strap B.


5 Lower the Strut Onto the Cylinder To prevent any chance of the loader arms creeping down and trapping your fingers, the loader arms should be carefully lowered onto the safety strut as shown.
  Start the engine and slowly lower the loader arms onto the safety strut, stop the movement immediately the weight of the loader arms is supported by the safety strut.
Note: When lowering the loader, operate the control lever carefully.' Feather' the lever to lower the loader very slowly.

.https://www.blogger.com

Removing

1 Fully Raise the Loader Arms To take the weight off the safety strut.

2 Stop the Engine Remove the starter key.
             WARNING
   You could be killed or injured if the loader control is accidentally operated. Make sure no one comes near the machine while you remove the safety strut.

3  Remove the Strut a Undo the strap B.
    b Remove the strut C from the ram piston rod.
 4  Stow the Strut Secure the strut in its stowage position with fastener A.

10.2022 JCB All ECU’s Modules Flash File Download